取消

磁选机褐铁矿磁选机河砂磁选机铁矿石磁选机河沙磁选机昆明磁选机小型磁选机盘式磁选机铁矿磁选机节能磁选机

商品
详情

智能磁选机

¥1.00 ≥1台起批

参数

是加工定制
DT类型
东唐品牌

发货地河北滦州市 3天内发货供货总量99台

唐山东唐电器设备有限公司: 进入店铺在线咨询

辊式强磁磁选机CSQ50*70二氧化三铁强磁选机实验室用湿式强磁选机 ¥6.50

实验室磁选管CXG-ZN50智能磁选管试验磁选机电磁除铁机50玻璃管 ¥1.89

自卸式永磁除铁器吸铁悬挂式除铁机矿用砐铁设备皮带输送磁选机 ¥2600.00

吊挂式永磁除铁机自卸式强磁除铁器全自动带式除铁设备干湿磁选机 ¥8800.00

褐铁矿筒式磁选机小型CTB湿式磁选机湿式磁选机平板磁选机 ¥1.55

生活垃圾焚烧炉渣灰磁选机定制废钢渣料TS9180除铁设备 ¥6.37

产品详情

磁选管又名戴维斯管。它适用于选煤、矿山、冶金、地质等实验室。用来测定强磁性矿石的磁性成分含量，为矿石的分选提供参考数据。

Magnetic tube is also called Davis tube, applied to coal preparation, mine, metallurgy, geology and other laboratories, used to measure the content of magnetic ingredient in the ferromagnetic ore. It supplies reference data for sorting of ore.

DTCXG-ZN50磁选管是在传统国标型磁选管基础上的改进产品，在测量原理及使用方法步骤等方面完全严格的按照***执行。其间对设备的整体结构及操作控制部分进行了创新升级。设备整体采用了新型车式结构设计，外形美观大方，移动灵活，使用方便。核心控制器采用计算机控制技术，全智能操控，可在测量时对磁场强度进行一键式全自动测量，并对磁场强度进行全数字化直接显示，操作简单，显示直观。磁场输出采用激磁控制模块，磁场强度无级线性调节，测量准确、运行可靠。为了***测量的准确性，每一台磁选管均在出厂前做了磁场强度的标定，完全符合《选煤用磁铁矿粉实验方法》（GB/T18711-2002第七节）对实验设备的要求。

DTCXG – ZN50 magnetic tube is the product improved based on CXG magnetic tube. It adopts new controllable power supply and excitation control to directly indicate the magnetic field intensity number. The magnetic field intensity is steplessly and linearly regulated and the key spare parts are greatly improved, so that it is more reasonable in structure, convenient in operation, accurate in measurement and reliable in operation. In order to guarantee accurateness of measurement, each magnetic tube is subject to calibration of magnetic field intensity, and fully conforms to requirement of experimental method of Magnetite for Coal Preparation (GB/T18711-2002 section 7) on experimental equipment.

2.产品型号说明：

2.The product model that

3.主要技术参数：

3. Main technical specifications:

3.1磁场参数

3.1 Magnetic field parameter

a. 磁极距离: 52 mm

a. Pole pitch: 52 mm

b. 磁场强度: 0-350 mT ；0-450 mT

b. Magnetic field intensity: 0 - 350 mT； 0 - 450 mT

3.2玻璃管参数

3.2 Parameter of glass tube

a. 直径: 50 mm

a. Diameter: 50 mm

b. 移动行程: 40 mm

b. Shift motion: 40 mm

3.3试样粒度：<0.5 mm

3.3 Sample Granularity: <0.5 mm

3.4电机

3.4 Motor

a. 电压: 220V/240V/380V

a. Voltage: 220V / 240V / 380V

3.5整机净重: 258 kg

3.5 Net weight of complete machine: 258 kg

3.6总体尺寸: 1000×580×1300 mm(包括支架和水箱)

3.6 Overall dimension: 1000×580×1300 mm (including support and water tank)

4.工作原理及结构：

4. Operating principle and structure:

4.1工作原理：

4.1 Operating principle:

DTCXG－ZN50型磁选管是在C形电磁铁的两极之间，装有玻璃管，作往复移动和旋摆。被分选的试样，在通过磁场区域时，磁性物附着于管壁，非磁性物在机械运动中被水冲刷而排出。

DTCXG – ZN50 magnetic tube is between the two poles of C-shape electromagnet and a glass tube is installed as reciprocating and swing. When the sorted sample passes through the magnetic field region, the magnetic substance are attached to the tube wall. The non-magnetic substances are discharged after flushed by water during mechanical movement.

4.2结构简介：

4.2 Structure introduction:

DTCXG－ZN50型磁选管的组成，如图1所示：

Composition of DTCXG – ZN50 magnetic tube is shown in figure 1:

a.支座(8)安装在底座(16)上，用来支撑C形铁芯(4)和激磁绕组(5)。

a. The support (8) is installed on the base plate (16) and used to support C-shape iron core (4) and field winding (5).

b.在铁芯上磁***装有连接环箍(14)，用来连接传动支架(13)。松开环箍上两边螺母，可调节玻璃管安装角度，一般为30度，调整完后，拧紧连接环箍上两边螺母。注意不要拧得过紧，以传动机架不能转动为止。

b. The connection tie hoop (14) is installed at pole end of the iron core and used to connecting the driving support (13). Loosen the nuts at both sides of the tie hoop to adjust the installation angle of the glass tube, which is 30° generally. After adjustment, screw the nuts down at both sides of the tie hoop. Do not tie it over-tightly; it will be suitable if the drive frame can not be turned any more.

c.玻璃管(15)被嵌在铜套(12)中，通过支架架在两磁极之间。用手先拿住玻璃管，松开调节螺栓，可以调节玻璃管位置，调好后拧紧螺栓。

c. The glass tube (15) is embedded in copper sheathing (12) and supported between two poles through a support. Hold the glass tube with hand at first; loosen the adjusting bolt to adjust the position of the glass tube. Screw down the bolt after adjustment.

d.电机通过曲柄使玻璃管作旋摆运动。

d. The motor drives the glass tube to perform swing movement through the crank.

玻璃管与水平线角度调节范围0度～40度。玻璃管行程40mm，旋摆45度。

Regulation range of the angle between the glass tube and the horizontal line is 0°～40°. The glass tube is 40mm in stroke and 45° in swing.

图1 DTCXG－ZN50型磁选管结构

Fig.1 structure of DTCXG – ZN50 magnetic tube

5.安装：

5. Installation：

5.1 将电源插头插入220V/240V/380V的插座上。

5.1 Insert the power plug into 220V / 240V / 380V electrical outlet.

5.2 将玻璃管(15)安装在主机托架上。

5.2 Install the glass tube (15) on the bracket of the mainframe.

5.3 安装漏斗、出水管与管夹。

5.3 Install the water pipe and tube funnel, clip.

5.4 水箱(1)安放在支撑架(2)上。

5.4 The water tank (1) is installed on the water tank support (2).

5.5 加电试验。

5.5 Power-on test

a.接好电源，确保无误。

a. Connect the power supply well to guarantee that it is correct.

b.打开“电源开关”，打开“电机启动开关”。（如有异常，立即关机，检查原因，重新调整）。如运转正常，安装调试完毕。

b. Turn on "startup of magnetic field power supply" switch and "motor power supply" switch (turn off it at once in case of abnormity, and inspect the reason and readjust it). The installation and debugging are finished if it operates normally.

为您推荐更多 >