HIMA Z7116 933236100-5伺服电机使用数量
¥3137.00
HIMA Z7126工业显示屏中文使用说明
¥3137.00
HIMA Z7127 936217500-5工业键盘使用配置手册
¥3137.00
HIMA Z7128控制器使用教程
¥3137.00
HIMA Z7136编码器用户手册
¥3137.00
HIMA Z7138PLC使用授权工控卡件
¥3137.00
产品标题：HIMA Z7116伺服驱动优势系列产品
型号：HIMA Z7116
质保：七天验收期，质保期一年
品牌：HIMA
产品图片展示
产品详情资料：
通过将“0”写入相应的“定时器x引起的IRQ”字段，可以清除特定的定时器中断。或者，写入适当的Timer x IRQ Clear（TxIC）寄存器也将清除中断。当使用“Timer x Caused IRQ”字段清除中断时，请注意，确保使用正确的位掩码以使其他寄存器设置不受影响非常重要。清除中断的方法是使用下面描述的“Timer x IRQ Clear”寄存器。定时器控制状态寄存器2（TCSR2）定时器也由位于BAR2地址偏移0x04处的定时器控制状态计数器2（TCSR2）中的位控制。该寄存器中的位映射如下
产品英文详情资料：
A particular timer interrupt can be cleared by writing a “0” to the appropriate “Timer x Caused IRQ” field. Alternately, a write to the appropriate Timer x IRQ Clear (TxIC) register will also clear the interrupt. When clearing the interrupt using the “Timer x Caused IRQ” fields, note that it is very important to ensure that a proper bit mask is used so that other register settings are not affected. The preferred method for clearing interrupts is to use the “Timer x IRQ Clear” registers described below. Timer Control Status Register 2 (TCSR2) The timers are also controlled by bits in the Timer Control Status Register 2 (TCSR2) located at offset 0x04 from the address in BAR2. The mapping of the bits in this register are as follows
在线问
