MVME162PA-344S调节器参数说明工控卡件PLC/DCS备件模块

¥3278.00 1 - 9
¥3137.00 ≥10

参数

工控产品产品特性
否是否进口
美国产地

发货地江西瑞昌市 1天内发货供货总量5173个

瑞昌明盛自动化设备有限公司 4年: 进入店铺在线咨询

MVME162PA-244LE说明书文档传感器工控卡件PLC/DCS备件模块 ¥3137.00

MVME162PA-244LN输入输出模块工控卡件PLC/DCS备件模块 ¥3137.00

MVME162P-242LSE端子板机械保护装置工控卡件PLC/DCS备件模块 ¥3137.00

MVME3604-5352工控卡件PLC/DCS备件模块自动化设备 ¥3137.00

MVME5500-0161工控卡件PLC/DCS备件模块自动化设备 ¥3137.00

MVME2604-1351工控卡件PLC/DCS备件模块 ¥3137.00

产品详情

产品标题: MVME162PA-344S调节器参数说明工控卡件PLC/DCS备件模块

型号：MVME162PA-344S

品牌：Motorola

产品图片展示

产品详情资料：

MVME162PA-344S

GND连接提供对背板（机架接地）的访问。如果电压源浮动以限制共模电压，则电压源的（-）侧也可以连接到COM端子。所示的可选跳线可用于配置用于4至20 mA输入的通道。通过安装250欧姆电阻器而不是跳线，可以将4至20 mA输入的分辨率从10位提高到约11位。将所有未使用输入的+和-端子连接在一起，以将未使用点的模拟输入表中的任何波动降至***。4通道模拟电流输入模块IC694ALG221提供四个模拟输入通道。该模块有两个可能的输入范围：▪ 4至20毫安▪ 0至20 mA模块配有两个量程跳线；一个用于频道1和频道2，另一个用于通道3和频道4。四个通道中每一个的转换速度为一到半毫秒。这为任何信道提供了两毫秒的更新速率。转换信号的分辨率在任一范围内为12位二进制（4096分之一）。

产品英文详情料:

The GND connection provides access to the backplane (frame ground). The (-) side of the voltage source can also be tied to the COM terminal if the source is floating to limit common-mode voltages. The optional jumpers shown can be used to configure a channel for use with 4 to 20 mA inputs. The resolution of 4 to 20 mA inputs can be increased from 10 bits to approximately 11 bits by installing a 250 Ohm resistor instead of the jumper Connect the + and - terminals together for all unused inputs to minimize any fluctuations in the analog input table for the unused points.The 4–Channel Analog Current Input module, IC694ALG221, provides four analog input channels. This module has two possible input ranges: ▪ 4 to 20 mA ▪ 0 to 20 mA Two range jumpers are provided with the module; one for channels one and two, and the other for channels three and four. Conversion speed for each of the four channels is one–half millisecond. This provides an update rate of two milliseconds for any channel. Resolution of the converted signal is 12 bits binary (1 part in 4096) over either range.