- 商品
- 详情
- 热插拔产品特性
- 否是否进口
- 美国产地
KOLLMORGEN CB06551 伺服控制器模块
KOLLMORGEN CB06551 伺服控制器模块是一款 6U 单插槽 VMEbus 伺服控制器，可为我们的嵌入式 VMEbus 处理器系列提供硬盘和软盘存储选项。该模块可以单独配置一个驱动器，也可以同时配置两个驱动器。闪存驱动器可作为选件提供。VME-7452 是无源 VMEbus 板，仅连接到 P2 用户定义的引脚、电源和接地。标准 VMEbus 6U 单插槽外形3.5 英寸 1.44 MB 软盘驱动器可选闪存驱动器低电量其振幅仅取有限值的信号称为数字信号。数字信号是离散的，它们只包含不同的值。类似地，频移键控使用恒定振幅载波信号和两个频率来区分1和0。
KOLLMORGEN CB06551 伺服控制器模块数字信号以位的形式携带二进制数据，即0或1，它在一段时间内只能包含一个值。数字信号表示为方波或时钟信号。最小值为0伏，而值为5伏。与模拟信号相比，数字信号较少受到噪声的影响。数字数据在模拟信道中的传输是通过一种称为调制的过程来完成的。振幅调制是使用单频载波信号将数字数据转换为模拟信号的过程。
The KOLLMORGEN CB06551 servo controller module is a 6U single slot VMEbus servo controller that provides hard disk and floppy disk storage options for our embedded VMEbus processor series. This module can be configured with either a single drive or two drives simultaneously. Flash drives are available as an option. VME-7452 is a passive VMEbus board that is only connected to P2 user-defined pins, power supply, and ground. A standard VMEbus 6U single slot 3.5-inch 1.44 MB floppy disk drive with optional flash drive. Low battery and limited amplitude signals are called digital signals. Digital signals are discrete and only contain different values. Similarly, frequency shift keying uses a constant amplitude carrier signal and two frequencies to distinguish between 1 and 0.
The digital signal of KOLLMORGEN CB06551 servo controller module carries binary data in the form of bits, namely 0 or 1, which can only contain one value at a time. Digital signals are represented as square waves or clock signals. The minimum value is 0 volts, while the value is 5 volts. Compared to analog signals, digital signals are less affected by noise. The transmission of digital data in analog channels is accomplished through a process called modulation. Amplitude modulation is the process of converting digital data into analog signals using a single frequency carrier signal.
在线问
- 热插拔
- 否
- 美国
- 否
- KOLLMORGEN
- CB06551
- 220
- 60
