can转wifi传输模块canblue II德国ixxat公司

¥4000.00 5 - 9个
¥3800.00 ≥10个

参数

是加工定制
IXXAT品牌
canblue II型号

发货地上海长宁区 15天内发货供货总量999个

上海前望电子科技有限公司 2年: 进入店铺在线咨询

can转蓝牙 can转蓝牙 ¥3800.00

can转无线 can转无线 ¥4000.00

支持安卓驱动应用的CAN卡：CANblue II ¥4000.00

带蓝牙功能的CAN卡：CANblue II支持安卓驱动 ¥4000.00

can转无线能配对代替电缆传输can信号300米超远距离 ¥4000.00

can无线传输模块canblue II德国ixxat公司 ¥3800.00

产品详情

can转蓝牙传输模块canblue II德国ixxat公司

can转蓝牙传输模块canblue II德国ixxat公司，300米距离，抗干扰性强，无需布线

CANblue II

Intelligent CAN Module with
Bluetooth Interface

The CANblue II is a reasonable and versatile CAN-Bluetooth module, which can be used in a wide
range of applications due three supported operation modes.
For service applications it enables e.g. the wireless access to CAN systems using the standard Bluetooth interface provided within many notebooks. Due to this, diagnostic data can be read or system configuration tasks can be performed very simple and flexible, even at components which are hard to reach.

Using several CANblue II devices network segments can be networked among each other. This enables the reliable connection of rotating or moving parts, e.g. in wind turbines, as well as the bridging of larger distances between different sub-systems up to 200 meters. Failure-prone slip ring connections or expensive installations of large CAN lines can such be avoided.

Not least, the Bluetooth-based communication also offers significant advantages in terms of range and noise immunity, compared to traditional WLAN solutions.

The following modes are supported:

Bridge mode
The bridge mode allows the user to set-up a CAN-Bluetooth-CAN bridge by using two CANblue II devices. Message exchange occurs on layer 2 and is transparent. The device can also be used in systems with CANopen, DeviceNet or customer-specific protocols. CAN-ID filters can be set for data exchange via Bluetooth. Using more than 2 CANblue devices, multiple busses can be linked with each other.

ASCII/Binary protocol mode
In this mode, functions for transmitting and receiving CAN messages and for configuring the CANblue II are available to the user based on simple ASCII commands and optimized CAN binary messages. The CANblue II is ideal for "non-Windows" systems or embedded platforms.

PC operation mode with VCI driver support
Because it is supported by the VCI CAN driver, the CANblue II can be operated with all IXXAT tools and with customer-specified programs. In addition, wireless access to CAN systems via Bluetooth can also be easily achieved with existing VCI-based application programs and tools.

Product highlights
- Quick start-up and connection
- High transmission range
- Low latency transmission
- High data throughput
- Flexible configuration options (combination of several CANblue II)

Technical Data

Bluetooth interface	Bluetooth specification V2.1 EDR, 200 m max. transmission range
Microcontroller	32-bit microcontroller
CAN controller	CAN 2.0 A/B
CAN bus interface	*** 11898-2, Sub D9 plug according to CiA 303-1
Galvanic ***lation	1 kV, 1 sec.
Voltage supply	9 - 30 V DC, 0.6 W
Temperature range	-40 ºC ... +85 ºC
Sending delay (average)	approx. 4 ms (in Shortest Latency Mode)
CAN performance at 1 Mbit	*** bus load
Certification	CE, FCC, Telec
Housing	Plastic housing with integrated antenna and mounting holes
Size	82 x 64 x 26 mm

For the bluetooth connection IXXAT uses the reliable bluetooth modules from connectblue

Accessories (only for the version with external antenna)

Antenna
Stub antenna with RPSMA plug,  90 degree tiltable.
(Technical data: Length 10 cm, 2,5 dBi, 2,4 Ghz, 50 Ohm impedance , half wave dipole, linear polarization)

Magnetic foot antenna
Antenna with a strong magnetic foot for mounting, 1,5 m cable and RP-SMA connectors.
(Technical data: Weight  150 g, diameter 47 mm, heigth 50 mm, designed for indoor use or outdoor use, provided that the antenna is protected against water and moisture.)

Screwable antenna foot
Screwable antenna foot with M8 screw, 1,5 m cable and RP-SMA connectors.
(Technical data: Weight  50 g, diameter 27 mm, heigth 47 mm, designed for indoor use or outdoor use, provided that the antenna is protected against water and moisture.)

Contents of delivery
- CANblue module and user&＃39;s manual
- CAN driver VCI for Windows
- Simple CAN tool "miniMon"

Order number

1.01.0126.12000	CANblue II - With integrated antenna
1.01.0126.12001	CANblue II - For usage with external antenna (not included in the scope of delivery)

Accessories

1.04.0085.00001	External antenna (only for 1.01.0126.12001)
1.04.0085.00000	Magnetic antenna foot with 1,5 m cable and RP-SMA connectors
1.04.0085.00002	Screwable antenna foot with 1,5 m cable and RP-SMA connectors

为您推荐