柳工电动叉车电瓶牵引车蓄电池

¥1999.00 ≥1组起批

参数

蓄电池产品特性
否是否进口
山东产地

发货地北京海淀区 3天内发货供货总量100组

北京旗益盛商贸有限公司: 进入店铺在线咨询

丰田/龙工/TCM/现代/江淮/BT电动叉车蓄电池堆高车电瓶 ¥1999.00

斗山/三菱/合叉/比亚迪/精工电动叉车电瓶防爆叉车蓄电池锂电池 ¥1999.00

火炬电动车铅酸加液蓄电池4-DG-140观光车高尔夫警务车电瓶8V ¥590.00

火炬蓄电池6-DG120型游览电动汽车三轮车高尔夫球车电瓶12V120AH ¥390.00

火炬动力蓄电池6-DG-140型拉货三轮车游览车电动汽车电瓶12V140AH ¥499.00

6-DG-160型火炬铅酸蓄电池12V160AH电动三轮车观光车电瓶 ¥599.00

产品详情

永恒力/诺力/住友/搬易通/大连/柳工电动叉车电瓶牵引车蓄电池

以下为行业相关信息，非广告内容，请选择性观看：

电动叉车进行蓄电池作为电解液“烧坏”的问题

应注意使用一段时间后出现的问题，例如使用时间短、充电异常、吸烟、电解液挥发过快...除了购买品牌和价格外，服务跟进也很重要，因此选择长期保修产品是明智的。叉车蓄电池液面：低于额定的液面，将缩短蓄电池的使用寿命，而且电解液太少将导致蓄电池发热损坏，因此，经常注意电解液是否足够。蓄电池充电：充电过程中蓄电池会产生气体，应保持充电场所通风良好，周围没有明火，同时充电过程中产生的氧气、酸性气体将对周围产生影响。充电期间拔下充电插头会产生电弧，将充电机关闭后，方可拔下插头。充电后在蓄电池周围滞留许多氢气，不允许有任何明火，应开启蓄电池上的盖板进行充电。铅酸蓄电池电解液泄露：电解液泄露到外部时，立即用石灰、强碳酸苏打或碳酸苏打等进行中和，并用大量的水冲洗。

电动叉车电池的问题是经常加入蒸馏水。如果你不小心，电解质将很快“烧毁”.这是叉车蓄电池的一大缺点。许多叉车电池制造商正在开发免维护的叉车电池。但反应不理想，射程短，无法举起重物。这种类型的电池已经运行了很长时间，甚至当它是浮动的。目的是维护电池。可以长期收费，但不能多收费。

阀控密封叉车蓄电池正常运行时，阀不得打开，酸雾不得溢出。 AGM阀控叉车蓄电池采用高吸液率的超细玻璃纤维作为隔板，采用密封组件，缩短氧离子从正极板到负极板的距离。

因此，密封叉车蓄电池在运行管理过程中可以释放的热量不易散失，在安装和运行发展过程中我们进行仔细考虑蓄电池的散热问题。为延长蓄电池寿命，整流器需要学生根据不同温度环境变化情况实时调整蓄电池浮充电压。一般这种情况下，阀控密封蓄电池基本信息无法。

The problem of electric forklifts using batteries as electrolytes to burn out

Attention should be paid to issues that may arise after a period of use, such as short usage time, abnormal charging, smoking, rapid evaporation of electrolyte In addition to purchasing brands and prices, service follow-up is also important, so choosing long-term warranty products is wise. Forklift battery liquid level: Lower than the rated liquid level will shorten the service life of the battery, and too little electrolyte will cause the battery to heat up and damage. Therefore, it is necessary to regularly pay attention to whether the electrolyte is sufficient. Battery charging: During the charging process, the battery will generate gas. The charging area should be well ventilated and there should be no open flames around. At the same time, the oxygen and acidic gases generated during the charging process will have an impact on the surrounding area. During charging, unplugging the charging plug will generate an arc. Only after turning off the charger can the plug be unplugged. After charging, a lot of hydrogen gas is trapped around the battery, and no open flames are allowed. The cover plate on the battery should be opened for charging. Lead-acid battery electrolyte leakage: When the electrolyte leaks to the outside, immediately neutralize it with lime, strong carbonated soda, or carbonated soda, and rinse with a large amount of water.

The problem with electric forklift batteries is the frequent addition of distilled water. If you are not careful, the electrolyte will quickly "burn out". This is a major drawback of forklift batteries. Many forklift battery manufacturers are developing maintenance free forklift batteries. But the reaction is not ideal, the range is short, and it is unable to lift heavy objects. This type of battery has been running for a long time, even when it is floating. The purpose is to maintain the battery. You can charge for a long time, but you cannot overcharge.

When the valve controlled sealed forklift battery is operating normally, the safety valve should not be opened and acid mist should not overflow. The AGM valve controlled forklift battery uses ultra-fine glass fiber with high liquid absorption rate as a separator, and uses sealed components to shorten the distance between oxygen ions from the positive plate to the negative plate.

Therefore, the heat released by sealed forklift batteries during operation and management is not easily dissipated, and we must carefully consider the heat dissipation of the batteries during installation and operation development. To extend the lifespan of the battery, the rectifier requires students to adjust the floating charge voltage of the battery in real-time according to different temperature and environmental changes. In this case, the basic information of valve controlled sealed batteries cannot be repaired.

为您推荐